MIL-DTL-484J
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is
not mandatory.)
6.1 Intended use. The cloth is intended for use in clothing where a high degree of wind
resistance and water resistance is of prime importance.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a. Title, number, and date of this specification.
b. Type of cloth required (see 1.2).
c. ASSIST will be cited in the solicitation, and if required, the specific issue of
individual documents referenced (see 2.2).
d. When first article is required (see 3.1, 4.2 and 6.3)
e. Color of cloth required (see 3.4).
f. Width of cloth required (see 3.6.1).
g. Length required if other than specified (see 3.12).
h. Packaging (see 5.1).
6.3 First article. When a first article is required, it will be inspected and approved under the
appropriate provisions of FAR 52.209-4. The first article should be a preproduction sample.
The contracting officer should specify the appropriate type of first article and the number of units
to be furnished. The contracting officer should include specific instructions in acquisition
documents regarding arrangements for selection, inspection, and approval of the first article.
(See 3.1 and 4.2).
6.4 Standard sample. For access to standard sample, address the contracting office issuing
the invitation for bids.
6.5 Fabric defect scales. Replica Kits are available from SEARS ROEBUCK AND CO., 333
Beverly Road, Hoffman Estates, IL 60179 Dept. 871HG, FC 568B. For information call (847)
286-8952.
6.6 Changes from previous issue. Marginal notations are not used in this revision to identify
changes with respect to the previous issues, due to the extensiveness of the changes.
6.7 Subject term (key word) listing.
Binding Interlining
Lining
Shell, Outer
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business