A-A-52104
Table I. Physical requirements
|
Characteristic |
Class |
Test method 1/ |
|||
|
1 |
2 |
3 |
4 |
||
|
Warp (yarns/inch): |
|
5050 |
|||
|
minimum |
8 |
9 |
11 |
11 |
|
|
maximum |
11 |
12 |
13 |
13 |
|
|
|
|||||
|
Filling (yarns/inch): |
|
5050 |
|||
|
minimum |
8 |
8 |
10 |
11 |
|
|
maximum |
11 |
11 |
12 |
13 |
|
|
|
|||||
|
Weight (oz. sq.yd.) 2/ |
6.7 |
7.2 |
9.0 |
10.8 |
5041 |
1/ The test methods indicated, from FED-STD-191 Textile Test Methods, have been found acceptable to determine if the cloth meets the stated requirements. If the Government requires proof that the cloth meets the stated requirements, the test methods indicated shall be used.
2/ A plus or minus tolerance of 5 percent in weight per square yard will be permitted.
2.3 Length and put-up. For government procurements only, unless otherwise specified (see 5.1), the cloth shall be furnished in continuous lengths, each not less than 25 yards. The cloth shall be put-up full width on rolls as specified in 4.1.
3. QUALITY ASSURANCE
3.1 Certification. The contractor shall certify, and maintain substantiating evidence, that the product offered meets the salient characteristics and requirements of this Commercial Item Description, and that the product conforms to the producer’s own drawings, specifications, standards, and quality assurance practices. The Government reserves the right to require proof of such conformance prior to first delivery and thereafter as may be otherwise provided for under the provisions of the contract.
3.2 Visual examination. Lots of cloth shall be inspected in accordance with MIL-STD-105. The inspection level shall be II and the acceptable quality level (AQL), expressed in terms of defects per hundred units, shall be 6.5. The lot size shall be expressed in units of yards. The sample unit shall be 1 linear yard. The cloth shall be examined for the following defects: hole, cut, tear, broken or missing yarns, open places exceeding four yarn diameters, floats or skips, spots or stains exceeding 2 inches in combined directions, and width which does not meet the specified requirement.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business