MIL-DTL-43685C
Lot size (yards)
Sample size (rolls)
1200 or less 1/
3
1201 up to and including 3200
5
3201 up to and including 10,000
8
10,001 up to and including 35,000
13
35,001 up to and including 150,000
20
150,001 and over
32
1/ If a lot contains fewer than 3 rolls, each roll in the lot shall be examined.
4.4.1.1 Length examination. Each roll of webbing and tape shall be examined for the defects
listed below. The sample shall consist of the applicable number of rolls indicated above. If the
total of the actual gross lengths of rolls in the sample is less than the total of the gross lengths
marked on the roll tickets, the lot shall be rejected.
Defects
Gross length less than specified minimum length or more
than specified maximum length
Gross length more than 2 yards less than gross length
marked on roll tickets
Any piece less than 3 yards in length
Any roll containing more than three pieces
4.4.2 End item testing. The webbing and tape shall be tested for the characteristics listed in
Table III. Except where otherwise specified, the methods of testing specified wherever
applicable and as listed in Table III shall be followed. All test reports shall contain the
individual values utilized in expressing the final result. The lot size shall be expressed in units of
1 linear yard. The sample unit for testing shall be 10 yards. The lot shall be rejected if one or
more sample units fail to meet any requirement specified. The sample size shall be as follows:
Sample size (sample units)
Lot size (yards)
800 or less
2
801 up to and including 22,000
3
22,001 and over
5
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business