MIL-DTL-10176K
3.10 Marking. The back of the cloth shall be marked "Back" at both ends of each roll with
letters not less than 1/2 inch in height (see 4.3.3.3). The marking shall be clearly legible in any
indelible marking medium used commercially.
3.11 Workmanship. The finished cloth shall conform to the quality established by this
document. The demerit points per 100 square yards when calculated as specified in section 4
shall not exceed the established maximum point value.
3.12 Toxicity. The finished fabric shall not present a health hazard when used as intended
and tested as specified in 4.3.5.
4. VERIFICATION
4.1 Classification of inspection. The inspection requirements specified herein are classified
as follows:
a. First article inspection (see 4.2).
b. Conformance inspection (see 4.3).
4.2 First article inspection. A first article, submitted in accordance with 3.1, shall be
inspected, examined for color, shade and defects and tested for the characteristics as specified in
Table IV.
4.3 Conformance inspection. Conformance inspection shall include the examination of
4.3.1, through 4.3.3 and the tests in Table IV as applicable. Sampling for inspection shall be
performed in accordance with ANSI/ASQ Z1.4 and with quality acceptance levels as specified in
the contract and/or order, except where otherwise indicated.
4.3.1 Material inspection. In accordance with 4.1 above, the material shall be inspected in
accordance with all the requirements of referenced documents, unless otherwise excluded,
amended, modified or qualified in this specification or applicable procurement documents.
4.4 Wool grade examination The wool shall be examined for grade (see 3.4.1.1) in the
undyed top form by comparison with the applicable U.S. Standard (see 2.2.2). In the event of a
dispute, the wool grade shall be determined by the width method (wedge). The sample unit shall
be 1 yard or top, prior to dyeing and to blending with polyester fibers. The sample size (number
of sample units) shall be as listed below. The lot size shall be expressed in units of one pound
and the results from each sample unit shall be reported separately. The lot shall be unacceptable
if a single sample unit fails to meet the required grade.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business