A-A-55281
points per 100 square yards. Point computation for lot quality and
individual roll quality shall be as follows:
Total points scored in sample X 3600
= Points per
Constructed width of cloth (inches) X total yds inspected
100 sq.yds.
4.4.1.1
Demerit points .
Demerit points shall be assigned as follows:
For defects
3 inches or
less in any dimension
- one point
For defects
exceeding 3
inches, but not
exceeding
6 inches in
any dimension
- two points
For defects
exceeding 6
inches, but not
exceeding
9 inches in
any dimension
- three points
For defects
exceeding 9
inches in any dimension
- four points
The following defects, when present, shall be scored four points for
each yard in which they occur:
Baggy, ridgy or wavy cloth; width less than specified; poor dye
peneration, mottled, streaky or cloudy; overall uncleanness.
4.4.1.2 Length examination . During the yard-by-yard examination,
each roll in the sample shll be examined for length. Any length found
to be less than the minimum specified or more than 2 yards less than
the length marked on the ticket shall be considered a defect with
respect to length. The lot shall be unacceptable if two or more rolls
in the sample are defective in respect to length. The lot shall be
unacceptable if the total of the actual lengths of rolls in the sample
is less than the total of the lengths marked on the tickets. the
rolls examined shall be those selected for the examination of
individual rolls.
4.4.1.3 Examination for shade . During the yard-by-yard examination,
each roll in the sample shall be examined for shade. Any roll in the
sample off-shade, shaded side to side, side to center, or end to end
shall be cause for rejection of the entire lot represented by the
sample.
4.4.1.4 Examination for face identification and compliance with the
Textile Fiber Products Identification Act
. During the yard-by-yard
examination, each roll in the sample shall be examined for the defects
listed below. The lot shall be unacceptable if two or more of these
defects occur:
Face identification missing from either or both ends.
Not labeled or ticketed in accordance with the Textile Fiber
Products Identification Act.
5.
PACKAGING
5.1 Preservation, packing, and marking . The preservation, packing,
and marking shall be as specified in the contract or purchase order.
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business