MIL-PRF-40039E
3.10 Toxicity. The cloth shall not be toxic to the skin, eyes or epidermis when used as
intended (see 4.4.10).
3.11 Face side identification. The face side of the cloth shall be identified by applying a
stamping on that side of the cloth with the word "Face" on each end of each individual piece.
3.12 Fiber identification. Each roll shall be labeled and ticketed for fiber content in
accordance with the Rules and Regulations Under the Textile Fiber Products Identification
Act.
3.13 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or
environmentally preferable materials should be used to the maximum extent possible
provided that the material meets or exceeds the operational and maintenance requirements,
and promotes economically advantageous life cycle costs.
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are classified
as follows:
a.
Qualification inspection (see 4.2).
b.
Conformance inspection (see 4.3).
4.2 First article inspection. When a first article is required (see 6.2) it shall be examined for
the defects listed in Table II and shall be tested for the characteristics specified in Table III.
4.3 Conformance inspection. Sampling for inspection shall be as specified in the contract or
purchase order.
4.3.1 End item examination.
4.3.1.1 Yard by yard examination. During the yard by yard examination, each roll in the
sample shall be examined for the defects listed below. The yardage of each roll in the sample
shall be examined on both sides. The yardage shall be given a through-light inspection for
pinholes and thin areas. The through-light inspection shall be performed in accordance with
MIL-STD-1487. The defects found shall be counted regardless of their proximity to each
other, except where two or more defects represent a single local condition of the cloth, in
which case only one defect shall be counted. A continuous defect shall be counted as one
defect for each warpwise yard or fraction thereof in which it occurs. The sample unit shall be
one linear yard.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business