MIL-PRF-19759F
Classification
Defect
Major
Minor
Any pinhole
119
Any transparent area or window
120
Any evidence of puckering, waviness or distortion
121
Off shade, shaded side to side, side to center, end to end, mottled,
122
cloudy or streaked 1/
Any area of general uncleanliness
205
Any tackiness, cloth adheres to itself and will not readily unroll
123
Any objectionable odor 2/
206
Any spot, stain, streak 3/:
less than 1 inch in its longest direction
207
1 inch or more in its longest direction)
124
Any imbedded foreign matter
125
Any brittleness (i.e., finish cracks when flexed (if finished)
126
Edges folded, rolled, or not cut straight
208
1/ Cloth which has been dusted with dusting powder shall be wiped with a wet cloth and
allowed to dry before color matching.
2/ Odors of chemicals or commonly used finishes (i.e., films and coating compounds) shall
not be regarded as objectionable.
3/ Clearly visible at normal inspection distance (approximately 3 feet).
4.3.1.2 Roll identification examination. During the yard-by-yard examination, each roll in
the sample shall be examined for proper identification. Any roll in the sample that is not
labeled or ticketed in accordance with the Textile Fiber Products Identification Act shall be
considered a roll identification defect.
4.3.1.4 Shade and appearance examination. During the yard-by-yard examination, each roll
in the sample shall be examined on the face side for shade and appearance. If any roll in the
sample is off shade or shaded side to side, side to center, or end to end, or if any roll does not
have the same appearance as the standard sample, the lot represented by the sample shall be
rejected.
4.3.2 End item. The cloth shall be tested for the characteristics listed in Table II. The
methods of testing specified wherever applicable and as listed in Table II shall be followed.
The lot shall be unacceptable if any sample unit fails to meet any requirement specified. All
test reports shall contain the individual values utilized in expressing the final results. The
sample unit shall be 3 continuous yards full width of cloth. The lot shall be unacceptable if
any sample unit fails to meet any requirement specified. The lot size shall be expressed in
units of one yard. The sample size shall be as follows:
Lot size (yards)
Sample size (sample units)
800 or less
2
801 up to and including 22,000
3
22,001 and over
5
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business