A-A-55242A
Smash
Any smash.
Tight pick or
Resulting in rolling of webbing; (any filling, edge noticeable
scalloped
indentation of edge).
Weak or tender
Any weak or tender spot clearly visible at spot normal inspection
distance (approximately 3 feet).
Wrong draw
Extending 9 linear inches or more.
Width
Less than minus tolerances, more than plus tolerance.
Label
Label missing, incorrect, or illegible; measurement of item not
as specified; bar-code omitted or not readable by scanner,
Human-Readable Interpretation (HRI) omitted or illegible; bar-
coded type not as specified code density not as specified.
5.5 Overall examination. Each defect listed shall be counted not more than once in each roll
examined. Each roll in the sample shall be examined over its entire length. If a lot contains
fewer than 3 rolls, each roll in the lot shall be examined.
5.5.1 Defects. The webbing shall be examined for the following defects:
Objectionable odor.
Uncleanness throughout.
Off shade, (not within established tolerance).
Poor color penetration, cloudy, mottled or streaky throughout.
Poorly constructed, not firmly and tightly woven.
Class 2 - Latex treatment not fully cured, tacky, uneven.
5.6 Length examination. During the overall examination, each roll in the sample shall be
examined for the defects listed below. In addition, the lot shall be rejected if the total of the
actual gross lengths of the rolls in the sample is less than the total of the gross lengths marked
on the roll tickets.
5.6.1 Defects. The webbing shall be examined for the following defects:
Gross length of roll is more than 2 yards less than the gross length marked on the ticket.
Length of roll not as specified in put-up paragraph.
Length of individual piece is less than 10 yards.
More than three pieces on a roll.
5.7 End item performance testing. The webbing shall be tested for the characteristics listed
in table IV below. The lot size shall be expressed in units of 1 linear yard. The sample unit
shall be as follows:
9 yards finished webbing (class 1)
25 yards finished webbing (class 2)
1 yard dyed, untreated webbing
The lot shall be unacceptable is one or more sample units fail to meet any requirement
specified. For breaking strength (initial and after abrasion) the lot shall be unacceptable if any
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business