A-A-52099
5/ The specimens must be dried after each of the three laundering cycles. On the color transfer cloth evaluation, only the stain on the cotton fibers of the color transfer cloth shall be evaluated.
6/ Refers to American Association of Textile Chemist and Colorists (AATCC) Chromatic Transference Scale rating.
7/ The specimens of type II cloth shall be a complete diaper, double layer and shall be cut the width of the cloth through the middle of the respective pinking bars, leaving a pinked edge. The samples shall be dried prior to pressing.
2.3 Length and put-up. For government procurements only, unless otherwise specified (see 5.1), the cloth shall be furnished in continuous lengths of not less than 30 yards and shall be put-up full width on rolls, or for General Services Administration (GSA) procurements 50 ± 1/2 yard rolls or bolts.
3. QUALITY ASSURANCE
3.1 Certification. The contractor shall certify, and maintain substantiating evidence, that the product offered meets the salient characteristics and requirements of this Commercial Item Description, and that the product conforms to the producer’s own drawings, specification, standards, and quality assurance practices. The Government reserves the right to require proof of such conformance prior to first delivery and thereafter as may be otherwise provided for under the provisions of the contract.
3.2 Visual examination. Lots of cloth shall be inspected in accordance with MIL-STD-105. The inspection level shall be II and the acceptable quality level (AQL), expressed in terms of defects per hundred units, shall be 6.5. The lot size shall be expressed in units of yards. The sample unit shall be one linear yard. The cloth shall be examined for the following defects: hole, cut, tear, missing end or pick, thick or thin areas, permanent crease, slubs, slugs or gout, shade bar, streaks, spots, stains or uneven dying.
3.3 Length examination. During the visual examination, each roll in the sample shall be examined for length. Any length found to be less than the minimum specified or more than 2 yards less than the length marked on the roll ticket shall be considered a length defect. If two or more rolls in the sample are defective with respect to length or if the total of the actual lengths of rolls in the sample is less than the total of lengths marked on the roll tickets, the lot shall be rejected.
3.4 Regulatory requirements. The offeror/contractor is encouraged to use recovered materials in accordance with Public Law 94-580 to the maximum extent practicable.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business