MIL-DTL-43191J
3.14 Workmanship. The finished cloth shall conform to the quality of product established
by this specification. The demerit points per 100 square yards when calculated as specified in
Section 4 shall not exceed the established maximum point values.
3.15 Toxicity. The finished fabric shall not present a health hazard when used as intended
when tested as specified in 4.4.2.
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are classified
as follows:
a. First article inspection (see 4.2).
b. Conformance inspection (see 4.3).
4.2 First article inspection. A first article, submitted in accordance with 3.1, shall be
inspected, examined for appearance, color and finished defects and tested for the characteristics
as specified in Table IX.
4.3 Conformance inspection. Conformance inspection shall include the examination of 4.4
and the tests of 4.4.2 through 4.5.3 as applicable. Sampling for inspection shall be performed in
accordance with ANSI/ASQ Z1.4 and with quality acceptance levels as specified in the contract
and/or order, except where otherwise indicated.
4.3.1 Material inspection. In accordance with 4.1 above, the material shall be inspected in
accordance with all the requirements of referenced documents, unless otherwise excluded,
amended, modified or qualified in this specification or applicable procurement documents.
4.4 Examination. Each roll in the sample shall be examined yard-by-yard on the face side
only. When the total yardage in the roll does not exceed 100 yards, the entire yardage in the roll
shall be examined. When the total yardage in the roll exceeds 100 yards, only 100 yards shall be
examined. All defects, as defined in Section I of FED-STD-4, that are clearly noticeable at
normal inspection distance (3 feet) shall be scored and assigned demerit points as listed in 4.4.1
except that only those slubs and knots which exceed the limits shown on the Sears Fabric Defect
Scale (see 6.6), "F" or "2" as applicable for slubs and "D" for knots, shall be scored. Print color
mark-off within 1-1/2 inches from either edge of the cloth shall not be scored as a defect. No
linear yard (increments of 1 yard on the measuring device of the inspection machine) from any
one roll shall be penalized more than four points. The sample size shall be 20 rolls selected from
20 containers. The lot shall be unacceptable if the points per 100 square yards examined exceeds
30.0 points. The lot shall be unacceptable if the points per 100 square yards of two or more
individual rolls exceeds 45.0 points. If one roll in the sample exceeds 45.0 points per 100 square
yards, a second sample of 20 rolls shall be examined for individual roll quality only. The lot
shall be unacceptable if one or more rolls in the second sample exceeds 45.0 points per 100
square yards. Point computation for lot quality and individual roll quality shall be as follows:
Total points scored in sample x 3600
= Points per 100
Contracted width of cloth (inches) x Total yards inspected square yards
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business