[INCH-POUND]
A-A-52086
January 10, 1991
COMMERCIAL ITEM DESCRIPTION
CLOTH, INTERLINING, COTTON WARP, RAYON FILLING
The General Services Administration has authorized the use of this commercial item description in preference to Military Specification MIL-C-43675(GL)
1. SALIENT CHARACTERISTICS
1.1 General description. The cloth shall be plain weave, one up-one down. The warp yarns shall be single ply cotton. The filling yarns shall be two ply rayon. The width shall be as specified (see 4.2) and shall be the minimum acceptable width inclusive of the selvage when fly-shuttle looms or shuttleless looms with tuck-in selvages are used. For all other shuttleless looms the width measurement shall be made between the last warp yarn on each side excluding the protruding fringe(s). The color of the finished cloth shall be natural. The cloth shall be given a clear permanent finish to equal the degree and character of the standard sample.
1.2 Physical requirements. The finish cloth shall conform to the requirements listed in table I.
1.3 Length and put-up. Unless otherwise specified (see 4.2), the cloth shall be furnished in continuous lengths each not less than 20 yards. The cloth shall be put-up full width on rolls as specified in 3.1
|
Beneficial comments, recommendations, additions, deletions, clarifications, etc., and other data which may improve this document should be sent by letter to: Commander, U.S. Army Natick Research, Development and Engineering Center, ATTN: STRNC-IRT, Natick, MA 01760-5019. |
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business